§ 17.20.200. Area and dimensional requirements.

A.

The following area and dimensional requirements apply to all C-O zones:

Table 17.20.200-1: Area and Dimensional Requirements
Measurement Type	Limit
Minimum lot area	3,000 sf
Minimum lot width/frontage	40 feet
Maximum building height	30 feet
Maximum lot coverage	50%
Maximum site coverage	75%
Minimum front setback	15 feet
Garage entrance setback	20 feet
Minimum rear setback	15 feet
Minimum side setback	5 feet
Minimum side setback (street)	5 feet
Minimum side setback (alley)	5 feet
Detached Accessory Structure Requirements
Minimum rear setback for accessory structures in the rear one-third of the lot	5 feet
Minimum side setback for accessory structures in the rear one-third of the lot	5 feet
Maximum building height	Not to exceed the primary structure building height
Maximum building footprint	Not to exceed the primary structure building footprint

 

Townhouses can be the width of the interior units.

Porches and covered entries may project up to six feet into the front setback.

Townhouses are exempt from side setback standards internal to a development. However, townhouse shall meet applicable side setback standards for adjacent lots outside of the development.

A 25% height bonus is available if the detached structure is within the building envelope required of a principal structure in the zone that the property is located.

B.

In locations where stormwater runoff from structures, driveways, sidewalks, patios and other surfaces is designed to infiltrate on-site, according to the requirements in Chapter 5 of the City of Port Angeles Urban Services Standards and Guidelines manual, portions of the project can be exempt from lot and site coverage calculations. (See PAMC 17.94.135 for exemptions.)

(Ord. 3577 § 1, 3/21/2017; Ord. 3572 § 8, 12/20/2016; Ord. 3343 § 7, 1/1/2009; Ord. 3272, 2/16/2007; Ord. 2715 § 4 (part), 10/16/1992; Ord. 2109 § 6, 12/7/1980)